Page 1 of 1
NOOB IF FT897 question
Posted: Sat Oct 08, 2016 2:42 pm
by pa5fdx
Hi I am using a PAT adapter board from sdrkits so my IF goes into the sdrplay. Where do I set my 70Mhz IF frequency?? in sdruno? It works great in HDSDR! But I can't figure out where to set the offset for IF in sdruno.
Re: NOOB IF FT897 question
Posted: Sat Oct 08, 2016 3:57 pm
by Misterj
pa5fdx, not sure I found anything useful to you, but click ADV (Show RSP Advanced Control Window) on the main window. Hovering the mouse over a settings almost always brings up a description. Do this on the various setting on the RSP Advanced Control Window and left and right click and see if any of these settings are useful. There are a number of windows to try this on, but this one looked the most promising to me. Good luck and enjoy, John.
Re: NOOB IF FT897 question
Posted: Sat Oct 08, 2016 4:37 pm
by pa5fdx
tnx but no joy there