SDRplay Community Forum

Hi,

SDRplay does not start at all if some other application has 'reserved' the RSP.

I think it should.

Because, SRDuno is not any good for making recordings.

The other one (HDSDR) is way much better in that.

I like to listen (already made recordings) while I'm also recording. Preferrably, with SDRplay.

Ok, the workaround is to use that other SW also for listening.

73, Jukka

Start by fixing this:
> You must enter at least two poll options.

Anything new for this - as SDRuno is recently updated?

My RSP2 is very busy almost all the time, monitoring and recording this and that, automatized, occupied by HDSDR.

Meanwhile, I would like to use SDRuno to listen my I/Q recordings. But, SDRuno refuses to start as there are "Not any RSPs available".

Any trick to overcome this?

73, Jukka

Hello Jukka,
This has been discussed and it is on the list of things to change in SDRuno. I'm afraid I cannot give you a schedule of when it will be done though. It is not quite as straightforward to implement as it might seem.

Sincerely

SDRplay Tech_Support

Oh:-I
But thanks for answering.

I have even thought buying a half-broken RSP (RF-end burned or like), but I don't have plans to visit my remote site in person during the winter months.

Luckily, two HDSDRs can be cheated to run at a same time.

Hey, actually my favorite solution would be: Just launch a serious upscale product, I'd buy it for being the second box - problem gone.

73, Jukka