Help need: Not tracking rig band changes
Posted: Wed Nov 22, 2017 12:11 pm
I have installed SDRUno 1.21 with omnirig on Win10. Rig FTdx3000.
As far as I can tell everything works great except:
SDRUno does not change bands when I change my rig's band and there after changing the rig freq. no longer is seen in Uno.
And after changing bands on the rig a terrible thing happens; after some variable amount of time, usually within a minute, SDRUno reverts the rig to the prior band. BAD!
Other than the above the CAT control works as expected; tracks rig mode changes and VFO changes for example. The rig follows band/mode/freq changes from SDRUno perfectly. I must have something configured wrong but I can't find what.
For reference I have SDRUno version 1.13 still installed and it does track my rig band changes. So I think this rules out omnirig and my rig.
Please can someone offer some help because I find the above problem a serious problem when I operating. It is extremely frustrating to have you rig change bands in the middle of a DX QSO!
As far as I can tell everything works great except:
SDRUno does not change bands when I change my rig's band and there after changing the rig freq. no longer is seen in Uno.
And after changing bands on the rig a terrible thing happens; after some variable amount of time, usually within a minute, SDRUno reverts the rig to the prior band. BAD!
Other than the above the CAT control works as expected; tracks rig mode changes and VFO changes for example. The rig follows band/mode/freq changes from SDRUno perfectly. I must have something configured wrong but I can't find what.
For reference I have SDRUno version 1.13 still installed and it does track my rig band changes. So I think this rules out omnirig and my rig.
Please can someone offer some help because I find the above problem a serious problem when I operating. It is extremely frustrating to have you rig change bands in the middle of a DX QSO!