Yaesu FTDX-5000 and SDRuno. (RIT does not work well.)
Posted: Wed May 30, 2018 11:18 am
Hello everyone,
I have detected a problem between my Yaesu FTDX-5000 MP and SDRuno (with RSP1A).
The scenario is the following:
Yaesu on the COM1 port configured through the Omnirig.
SDRuno is synchronized, RSYN1 button marked.
The options are also marked:
SYNC VRX → RIG
SYNC RIG → VRX
Everything works fine, except the RIT.
I explain:
When I use the RIT, the tuning control of the RIT becomes the main dial and also the RIT does not keep the displacement, always returning to zero.
If I uncheck the option SYNC RIG → VRX the RIT works. But I no longer have full synchronization.
I discard Omnirig, because with other sofwares the RIT works well.
Any suggestions ??
73 de Dani EA5FV.
I have detected a problem between my Yaesu FTDX-5000 MP and SDRuno (with RSP1A).
The scenario is the following:
Yaesu on the COM1 port configured through the Omnirig.
SDRuno is synchronized, RSYN1 button marked.
The options are also marked:
SYNC VRX → RIG
SYNC RIG → VRX
Everything works fine, except the RIT.
I explain:
When I use the RIT, the tuning control of the RIT becomes the main dial and also the RIT does not keep the displacement, always returning to zero.
If I uncheck the option SYNC RIG → VRX the RIT works. But I no longer have full synchronization.
I discard Omnirig, because with other sofwares the RIT works well.
Any suggestions ??
73 de Dani EA5FV.