Transverter / Converter setup

Discussions about everything to do with SDRuno
Post Reply
RobBarter
Posts: 1
Joined: Mon Jun 10, 2019 2:09 pm

Transverter / Converter setup

Post by RobBarter » Tue Jun 11, 2019 7:49 pm

Hi,

Apologies if you've also seen my same question over on the Facebook page yesterday. Not sure how much overlap there is.

Is there a simple guide I can be pointed to to setup SDRuno for use with a transverter?
I have a RSP2pro that is connected to the 28MHz output of a Kuhne 28/1296MHz transverter. I've tried changing the Offset in the 'Main Settings' but it doesn't seem to do what I was expecting (I typed in 1268000000 into OFFS1). I'm expecting to be able to type in an RX frequency in the RX Control Window of say 1296.200MHz and see my injected test signal which would have been downconverted to 28.200MHz.

I'm sure it's a simple thing but can I get it to work?!? Just looking for (further) confirmation that I'm an idiot and the solution is very simple.

Cheers
Rob - M0ZAF
Last edited by RobBarter on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

sdrom33
Posts: 128
Joined: Sun Dec 09, 2018 4:38 pm

Re: Transverter / Converter setup

Post by sdrom33 » Wed Jun 12, 2019 4:35 am

You must type in freq. In MHz.

Reason: No reason

Post Reply