Using SDRUNO iCOM IC-7610
Posted: Mon Aug 26, 2019 2:35 pm
Hi,
I'm not even sure this is possible but I'm trying to use the SDRUNO EXTIO application to control my 7610. I have managed to get SDRUNO to see the 7610 as an input by placing the 7610 EXTIO.dll file in the documents folder of Windows. When I try to run SDRUNO though it reports that it can't find FTD3xx.dll. I could place the FTD3xx.dll so that SDRUNO can find it but I'm not sure where this is supposed to be - I have tried in the SDRUNO folder, the documents folder and the Windows/system32 folder where the rest of the dlls seem to be.
Any help would be appreciated!
I'm not even sure this is possible but I'm trying to use the SDRUNO EXTIO application to control my 7610. I have managed to get SDRUNO to see the 7610 as an input by placing the 7610 EXTIO.dll file in the documents folder of Windows. When I try to run SDRUNO though it reports that it can't find FTD3xx.dll. I could place the FTD3xx.dll so that SDRUNO can find it but I'm not sure where this is supposed to be - I have tried in the SDRUNO folder, the documents folder and the Windows/system32 folder where the rest of the dlls seem to be.
Any help would be appreciated!