SDRPlay +SDRUno/SDRTouch - Windows/Android system requirements?

General discussions
Post Reply
Zonk666
Posts: 3
Joined: Mon Dec 04, 2017 11:50 am

SDRPlay +SDRUno/SDRTouch - Windows/Android system requirements?

Post by Zonk666 » Mon Jan 28, 2019 1:38 pm

Hello.

I´m planing to build a SDR World Band Receiver.

I´d like to do this with my SDRPlay RSP2 a windows or wndroid tablet, a tiny NF amp, two speakers, may be a power supply in addition.
The housing would be made with a 3d printer.

Now i have to know wich specs the needed tablet must have.

My experience with windows (8 / 10) tablets and notebook aren´t that good.
I tried a
2016 Dell Venue 7140 Pro (CPU M-5Y71 up to 2,9GHz, 8GB RAM)
2018 Dell XPS 9250 (CPU M5-6Y57 up to 2,8GHZ, 8GB RAM)
2013 DELL Latitude E5530 (CPU Core i3 3120M up to 2,5GHz, 4GB RAM)
2013 Asus Prime ux31 (CPU i7-3517U up to 2,8GHz, 4GB RAM)
On all these (windows) tablets/notebooks the audio began stuttering after raising the bandwith more than 4 or 6 MHz.

Funnily the old Dell Latitude E5530 did the best job.

So i need your experience what windows hardware would be the best for my project.
I like to use SDRUno.
Note, i dont like to take a 2k Tablet for the this project.

If there is no good windows hardware i´d like to try android (tablet 10,1" up to 14") with SDRTouch wich is not my prefered sofware.

So, what do you think about my projekt?

best regards
Last edited by Zonk666 on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

Post Reply