SDR UNO V1.3 Max. RF Gain in HI Z mode
Posted: Sun Apr 07, 2019 7:18 pm
I am using an RSP1A and have found that since upgrading to SDR UNO V1.3 (from V1.2) the RF gain control will always be at maximum when the program opens in HI Z mode. I can reduce it but it will always open nest time at maximum.
Also the MW/FM notch selector button is visible even though the HI Z input is selected.
If I click on ANT A or ANT B and go back to HI Z the notch button will disappear and then everything is normal again.
I have tried saving the workspace before closing but it still opens next time with the same problem
I have completely removed all traces of old installations and performed a clean install of V1.3 but the problem remains.
Any ideas?
Thanks
Mike
Also the MW/FM notch selector button is visible even though the HI Z input is selected.
If I click on ANT A or ANT B and go back to HI Z the notch button will disappear and then everything is normal again.
I have tried saving the workspace before closing but it still opens next time with the same problem
I have completely removed all traces of old installations and performed a clean install of V1.3 but the problem remains.
Any ideas?
Thanks
Mike
