SDRplay Community Forum

This forum is now suspended and will not accept any new posts or account registrations. For technical support relating to SDRplay hardware or software, please open up a support ticket via www.sdrplay.com/support
https://www.sdrplay.com/community/

GNUradio

https://www.sdrplay.com/community/viewtopic.php?f=5&t=884

Page 1 of 1

GNUradio

Posted: Fri Jul 15, 2016 9:24 pm
by signon
Hi everyone,

Can you tell me how can I pass some parameters to my SDR in GNUradio by command line? Parameters like frequency, if the gain is manual or not, etc...


Thanks a lot,

SIGNON

Re: GNUradio

Posted: Sat Jul 16, 2016 7:11 am
by sdrplay
I don't think so. Gnu Radio is a modular system where you place blocks for sources, etc. - you specify the parameters in the source as values or variables that you can set from elsewhere in your function.

Best regards,

SDRplay Support

Re: GNUradio

Posted: Sat Jul 16, 2016 11:37 am
by signon
is there any possible way to change those parameters without a graphical interface?


Best regards,
SIGNON
All times are UTC
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/