Is the RSP1 significantly worse in the AM band compared to RSP2
Posted: Fri Oct 13, 2017 10:29 am
I have been trying to receive signals in the 100kHz to 2MHz range on my RSP1 without much success. I have since had the opportunity to try out an RSP2 and have found that with the same antenna, same SDR Uno settings I can receive loads of signals. I'm using Port A on the RSP2 which isn't even rated for below 1.5MHz but it works much much better than the RSP1. Even using a small whip antenna the RSP2 will pick up broadcast radio stations in the band whereas the RSP1 shows absolutely nothing.
Is this normal expected behaviour or does my RSP1 have a fault?
Thanks
Richard
Is this normal expected behaviour or does my RSP1 have a fault?
Thanks
Richard