SDRplay Community Forum

Posted: **Sat Jan 06, 2018 11:14 pm**

Today I connected a short wire antenna using the Hi-Z port to listen to some HF. Everything was operating properly, until later in the day I re-launched CubicSDR.

The software "sees" the SDRplay, but CubicSDR doesn't show a waterfall and there is now audio. My computer is also recognizing the device in the system report. Unsure if this is noteworthy or not. I'm not able to "hide" the CubicSDR application on my desktop.

So far, I have re-seated the usb connection and I've re-installed the API/HW drivers and Cubic SDR. I'm attempting to attach screen grabs.

: Screen Shot 2018-01-06 at 5.57.21 PM.png (202.01 KiB) Viewed 10406 times

: Screen Shot 2018-01-06 at 5.48.46 PM.jpg (199.76 KiB) Viewed 10406 times

: Screen Shot 2018-01-06 at 5.49.49 PM.jpg (197.53 KiB) Viewed 10406 times

Thanks for any ideas and help!

Posted: **Sun Jan 07, 2018 1:24 pm**

Set RF gain reduction (RFGR) to 0 - depending on the frequency, 8 is probably out of bounds.

If you are still having problems, come through to Support (https://www.sdrplay.com/support)

Best regards,

SDRplay Support

Posted: **Sun Jan 07, 2018 8:49 pm**

thank you. After a couple of computer re-starts, I re-seated the USB at the SDRplay. Suddenly it worked

SDRplay Community Forum

SDRplay RSP 2 has ceased operating properly on MAC/CUBICSDR

SDRplay RSP 2 has ceased operating properly on MAC/CUBICSDR

Re: SDRplay RSP 2 has ceased operating properly on MAC/CUBICSDR

Re: SDRplay RSP 2 has ceased operating properly on MAC/CUBICSDR