SkimmerServer and RSPDuo - crash when changing config
Posted: Thu Dec 20, 2018 3:23 pm
Hi all - support - Steve,
I have an issue with CW Skimmer Server:
* When doing and confirming (Apply or OK) any change in Skimmer, Telnet and/or Operator Tab the SkimSrvr stop running and close (even when clicking APPLY without having done any change)
My setup:
SDRplay DUO
CW Skimmer Server:
* Skimmer Server V1.6
* SDRplayintf.dll (V1.3) installed in the same directory
* Win 10 o/s
Initial status:
* The Server run and start monitoring the first band.
* Status is OK (Telnet Server OK and SDR Receiver OK)
* Segment at start 7, 14, 21 MHz
* Band rotation ok after 2 mins
Is this a limitation in the SDRplayintf.dll that does not allow changes in the setting file?
Ho can I diagnose?
SkimSrv TelnetServer log just report:
- Starting server on port 7300
- server started
Thanks, 73
Alessandro i2sva
I have an issue with CW Skimmer Server:
* When doing and confirming (Apply or OK) any change in Skimmer, Telnet and/or Operator Tab the SkimSrvr stop running and close (even when clicking APPLY without having done any change)
My setup:
SDRplay DUO
CW Skimmer Server:
* Skimmer Server V1.6
* SDRplayintf.dll (V1.3) installed in the same directory
* Win 10 o/s
Initial status:
* The Server run and start monitoring the first band.
* Status is OK (Telnet Server OK and SDR Receiver OK)
* Segment at start 7, 14, 21 MHz
* Band rotation ok after 2 mins
Is this a limitation in the SDRplayintf.dll that does not allow changes in the setting file?
Ho can I diagnose?
SkimSrv TelnetServer log just report:
- Starting server on port 7300
- server started
Thanks, 73
Alessandro i2sva