Lots of noise...no signal...new unit
Posted: Tue May 14, 2019 12:23 pm
Just bought the SDR2PRO and did a fresh install as per instructions on my desktop running windows 10.
Everything loaded ok....but all I hear is noise. Tried all ant ports with same results. Thought it was the unit and took it back to the vendor. He installed software using windows 7....no problem. Worked like a charm...on all 3 ant ports. I left feeling pretty stupid.
Came home, uninstalled everything, reinstalled as per instruction....still same issue. However, without ant noise floor was about -130 dbm, with ant about -120dbm.
I did not change any settings other than selecting which ant port to use.
Installation procedure was identical to what the vendor did. We both installed the latest version of software.
I'm at a loss. Any ideas or suggestions?
Cheers
Richard - VE3FAC
Everything loaded ok....but all I hear is noise. Tried all ant ports with same results. Thought it was the unit and took it back to the vendor. He installed software using windows 7....no problem. Worked like a charm...on all 3 ant ports. I left feeling pretty stupid.
Came home, uninstalled everything, reinstalled as per instruction....still same issue. However, without ant noise floor was about -130 dbm, with ant about -120dbm.
I did not change any settings other than selecting which ant port to use.
Installation procedure was identical to what the vendor did. We both installed the latest version of software.
I'm at a loss. Any ideas or suggestions?
Cheers
Richard - VE3FAC