Using RSP1A for AIS signals

Post information or questions regarding SDRplay products here
Post Reply
elektray
Posts: 1
Joined: Thu Sep 12, 2019 8:58 am

Using RSP1A for AIS signals

Post by elektray » Thu Sep 12, 2019 9:07 am

Hello,

I've recently bought an SDRplay RSP1A device and being a complete beginner I would like to ask for some advice.

I would like to receive, decode AIS signals and store them in JSON format. I've done a lot of reading online but I still don't know what is the easiest and best set up/software to use. I was thinking of using the SRDPlay Raspberry Pi image to start with, but I was warned it may not perform well.

Do you know any useful resources I could look at? Any help is much appreciated.

Thank you
Daniela
Last edited by elektray on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

User avatar
mikeladd
Posts: 191
Joined: Wed Jul 08, 2015 3:18 am

Re: Using RSP1A for AIS signals

Post by mikeladd » Thu Sep 12, 2019 4:10 pm

Not sure if MultiPSK will output in the format you wish but you can use two instances of MultiPSK and 2 VRX's in SDRuno to decode AIS signals. Here are a few links that might help you. You will need a way to digitally pipe the audio from SDRuno into the decoder. I recommend VBcable

VBCable
https://www.vb-audio.com/Cable/

Support forum for MultiPSK
https://groups.io/g/multipsk

https://youtu.be/NEqvSxl4CPw

https://youtu.be/ndUPm6Nccb8

Reason: No reason

Post Reply