Tuning Freq's From the Memory ?

Discussions about everything to do with SDRuno
Robert11
Posts: 80
Joined: Fri Sep 28, 2018 12:00 pm

Tuning Freq's From the Memory ?

Postby Robert11 » Sat Mar 16, 2019 12:20 pm

Hello,

Have been able to import eibi into the Memory panel screen.
Shows up fine.

But clicking on a frequency does not seem to tune the radio.
However, if I do a STORE first on a particular frequency, it does tune fine.

What I would like to be able to do, I think, is to simply
go down the list, and click on different frequencies, and have
the radio tune to that one (without the STORE first requirement for that frequency).

How do I do this, please ?

I should note that I am using CSVUserListBrowser to tune the radio.
It works fine doing this.

Is this interfering with the above, or more likely I just don't know how
to tune the radio directly from the eibi listing in the Memory Panel.
I would like both capabilities, if possible.

BTW: for any frequencies that I actually do a STORE on: How do I recall them ? Where do they show in some list ?

Thanks, as always. In my 80's now, and I admit that I miss many of the nuances apparently.
Really appreciate the help.

BTW: if anyone might take a look at my one or two previous very recent questions, too, would be grateful.
Thanks,
Bob

Reason: No reason

mikeladd
Posts: 136
Joined: Wed Jul 08, 2015 3:18 am

Re: Tuning Freq's From the Memory ?

Postby mikeladd » Sat Mar 16, 2019 3:46 pm

Check that the (MCTR) button is active and lit within the RX CONTROL panel. This will activate memory click tuning.

Reason: No reason


Return to “SDRuno”

Who is online

Users browsing this forum: No registered users and 4 guests