Two "Housekeeping" Questions
Two "Housekeeping" Questions
ello,
Two not very important questions, please:
a. is there a global command somewhere to close out all screens, AND Exit the program at the same time ?
b. Let's say I have one or two screens I haven't been using, and have closed them out.
How do I "re-activate" and show them again ?
e.g., is there a drop down list somewhere to click on what screens you want to show and be active ?
If so, where ?
Thanks,
Bob
Two not very important questions, please:
a. is there a global command somewhere to close out all screens, AND Exit the program at the same time ?
b. Let's say I have one or two screens I haven't been using, and have closed them out.
How do I "re-activate" and show them again ?
e.g., is there a drop down list somewhere to click on what screens you want to show and be active ?
If so, where ?
Thanks,
Bob
Reason: No reason
Re: Two "Housekeeping" Questions
a. is there a global command somewhere to close out all screens, AND Exit the program at the same time ?
Click the top right X within the MAIN panel
b. Let's say I have one or two screens I haven't been using, and have closed them out.
How do I "re-activate" and show them again ?
Clicking the associated panel via the MAIN panel(SP1, SP2, RX, SCANNER, REC PANEL)
Click the top right X within the MAIN panel
b. Let's say I have one or two screens I haven't been using, and have closed them out.
How do I "re-activate" and show them again ?
Clicking the associated panel via the MAIN panel(SP1, SP2, RX, SCANNER, REC PANEL)
Reason: No reason