One Major Issue with New SDR# VER 2.0 ExtIO

Post information or questions regarding SDRplay products here
Post Reply
User avatar
Stan
Posts: 11
Joined: Thu Apr 02, 2015 11:05 pm

One Major Issue with New SDR# VER 2.0 ExtIO

Post by Stan » Wed May 13, 2015 9:42 pm

I have both versions 1.5 and 2.0.
I'm not running the latest greatest computer, but with ver 1.5 if I were to accidentally go above 2ghz the program would politely tell me it's out of range, and I dial back the frequency and everything is okay. With ver 2.0 however it just bogs the computer down so bad it becomes unresponsive. I'm not running the fastest computer out there but it works fine under normal conditions.
Last edited by Stan on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

jon
Posts: 433
Joined: Tue Jan 06, 2015 10:48 am

Re: One Major Issue with New SDR# VER 2.0 ExtIO

Post by jon » Thu May 14, 2015 7:36 am

Thanks for alerting us. We are working hard on an update. We will try to confirm timescales in the next day or so. Jon, on behalf of the SDRplay team
Last edited by jon on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

g1hbe
Posts: 494
Joined: Sat Jan 17, 2015 3:28 pm
Location: Cheshire, UK

Re: One Major Issue with New SDR# VER 2.0 ExtIO

Post by g1hbe » Thu May 14, 2015 12:48 pm

I get the same effect. As I tune abouve 2 GHz, the receiver stops working (as expected), but dialling back to below 2 GHz and re-starting SDR# just causes an 'out of range, hardware not initialised' message (or words to that effect). At this point, everything runs very slowly and the only way out is to shut SDR# down and start again. Everything works then.
Last edited by g1hbe on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Andy

User avatar
Stan
Posts: 11
Joined: Thu Apr 02, 2015 11:05 pm

Re: One Major Issue with New SDR# VER 2.0 ExtIO

Post by Stan » Thu May 14, 2015 3:21 pm

Glad to help iron out issues.
Stan.
Last edited by Stan on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

Post Reply